Trimesh in cross section plot

Bhavesh Bhatt · Post by **Bhavesh Bhatt** » Tue Aug 09, 2016 2:45 pm

I tried to add multiple trimesh models in Corridor part of ppf editor. But it doesn't plot in Autocad cross section output.
Does anyone have an idea to get trimesh plotted in cross section output.

Thanks.

Graeme Winfield · Post by **Graeme Winfield** » Tue Aug 09, 2016 3:09 pm

Hi Bhavesh

It was great to catch up with you again at the 12d International Conference last month.

Have a look at this post
http://forums.12dmodel.com/viewtopic.ph ... highlight=

Bhavesh Bhatt · Post by **Bhavesh Bhatt** » Tue Aug 09, 2016 3:30 pm

Thanks Graeme for the quick response.

It seems that the link you have posted does not have any content.

Post by **Lee Gregory** » Tue Aug 09, 2016 3:46 pm

Please try the link again.
I tried it and it worked.

Graeme Winfield · Post by **Graeme Winfield** » Tue Aug 09, 2016 4:08 pm

Do you access to the Design section?

or is it locked?

Bhavesh Bhatt · Post by **Bhavesh Bhatt** » Tue Aug 09, 2016 4:12 pm

Aha! you guessed it right. I do not have access to other than 12d practice version forum.

Graeme Winfield · Post by **Graeme Winfield** » Tue Aug 09, 2016 4:26 pm

At the top of the Page is the word register. Pick on this word and follow the prompts.

The Forum is a great resource

Bhavesh Bhatt · Post by **Bhavesh Bhatt** » Tue Aug 09, 2016 5:08 pm

I have submitted by dongle number and requested full access.
Thanks