X-section Error Plot

Any questions regarding the practice version are asked and answered here.
Post Reply
Kyle J Kucharski
Posts: 16
Joined: Mon Nov 16, 2015 11:50 am

X-section Error Plot

Post by Kyle J Kucharski »

Hi,

I have set up a PPF file and it has worked for the most part however recently I've been getting the following error (V10)

"cannot use style <0> for basic line work. must be a linestyle"

It will only plot some of my sections, but not all of them. I can't seem to work the problem out. I have checked my models and of course they have both linestyles 1 and 0 through them because there are points and lines but I wouldn't have thought having points in my model would stop the xsection from plotting.

r am I wrong?

Also, when it talks about basic linework, is that relating to the xsection model I am using, or the models that I am plotting in the xsection.

Regards,
KK
Owen Thornton
Posts: 5607
Joined: Tue Oct 04, 2005 12:50 pm
Location: Brisbane
Contact:

Post by Owen Thornton »

Hi Kyle,

Try setting all your "0" linestyle strings to linestyle "1". There is a separate setting on strings, to specify if they are point-strings or line-strings that is unrelated to linestyle. Only line-strings have a line drawn from vertex to vertex, regardless of the linestyle.

Are there point-strings in your model of primary x-sections? I can imagine that might cause issues, as the Xplot isn't really intended for that.

Owen.
Post Reply