Corner of Grading Batter conflict

Any questions regarding the practice version are asked and answered here.
Post Reply
Janet Manzano
Posts: 22
Joined: Fri Jul 13, 2007 3:28 pm
Contact:

Corner of Grading Batter conflict

Post by Janet Manzano »

I got a building pad a closed polyline, what I did, I convert it to super alignment, assign a constant elevation, then create a template of 2m offset all around and downgrade it to 3% before use a 1:5 drape to existing ground, the result is not good looking, the corners are just joined instead of actual curved shaped grading, any idea to resolved it?
Lucien West
Posts: 1115
Joined: Fri Oct 21, 2005 7:51 am

Post by Lucien West »

Project->management->defaults set Corner angle to something other than 0°.

This will help on outside bends, inside bends you will need to stop and start your template to stop the overlaps. Use an apply many.
Janet Manzano
Posts: 22
Joined: Fri Jul 13, 2007 3:28 pm
Contact:

corner of grading batter conflict

Post by Janet Manzano »

its still not working sorry
Lucien West
Posts: 1115
Joined: Fri Oct 21, 2005 7:51 am

Post by Lucien West »

There was a bug with corner angles in one or two of the releases, i think it was version 8.0c1g or 8.0c1f.
If your running one of these update your install to the latest 8.0c1p.
Janet Manzano
Posts: 22
Joined: Fri Jul 13, 2007 3:28 pm
Contact:

Post by Janet Manzano »

hi, im using Version 7
how can i email u the screen shot of the dwg i got now so u can see exactly whats happening?

thanks,
Janet
Post Reply