Contouring without contouring batters

JASON HOUGHOUGHI · Post by **JASON HOUGHOUGHI** » Thu Jun 26, 2008 3:41 pm

test please ignore

Sam Cech · Post by **Sam Cech** » Fri Jun 27, 2008 5:39 am

you could fence areas of interest
and if you create a chain with the Contours function and this Fence it will happen quickly and every time.... way faster than trim in Acrap.

Position of option on menu: Utilities =>Fence =>Fence
Position of option on menu: Utilities =>Chains =>Create

Lucien West · Post by **Lucien West** » Fri Jun 27, 2008 9:33 am

Use one of the slope analysis rountines to create boundary lines, which you can then use in a multifence outside to trim the contours using the model of boundarys.

In the slope analysis use a range file specifiying grade 1in
ranages 2 to .0001. ( may need to reverse???)

I thought I got the procedure from the Frequently Asked Questions section of the forum, but couldn't find it again, or the one I saved away.