Plot Long Section one Model

NAZRUDIN AHWARI · Post by **NAZRUDIN AHWARI** » Thu Oct 09, 2008 2:15 pm

Hi All

Can you help me ?

I have a problem, what 12D can long section ploting from 0 (zero) chainage to end chainage. I have end chainage 64000
can 12D Ploting into one Model or one file to DWG

Thanks your Attention

Regards

Nazrudin Ahwari

Lucien West · Post by **Lucien West** » Thu Oct 09, 2008 6:09 pm

Can plot to one file or model. Need to specify/ type in a sheet size that is big enough to fit enitre length and also make sure pagniation is turned off.

Pagnation can be toggled on and off. In the left edge panel, open out - Section Long Plot->Paganagtion (pick) in the right panel you will see "Use Pagnation" toggle off the tick box.

Sheet Size can be typed in manually using width hieght eg... 595 65000
If you think you will need this sheet size regularly you can add it the "sheets.4d" file, it will then show up in the drop down list
eg.. sheets.4d file entry

Code: Select all

"Large" 595 65000

Large will be the name shown in drop down list.

NAZRUDIN AHWARI · Post by **NAZRUDIN AHWARI** » Thu Oct 09, 2008 8:38 pm

Hi Lucien

Thanks a lot for information

I have tried and success

I change sheet size

regard

nazrudin