I HAVE DESIGN STRINGS FROM MY CLIENT. I HAVE REMOVED UNWANTED STRINGS FOR THE ALIGNMENT. THEN RUN THE APPLY MTF RECREATE. AS YOU CAN SEE FROM THE SCREEN SHOT THE CROSS SECTION HAVE NOT EXTENDED OUT ALL THE WAY TO THE DESIGN STRINGS.
IT HAS IN SOME LOCATION ALONG THE ALIGNMENT IS HAS EXTENDED OUT TO THE LAST STRING.
WHAT WILL CAUSE THIS TO HAPPEN?
APPLY MTF RECREATE
-
Samuel Van Eldik
- Posts: 16
- Joined: Fri Apr 01, 2011 11:55 am
- Location: Exmouth
- Contact:
Re: APPLY MTF RECREATE
Caps Lock
no screen shot attached
no screen shot attached
-
Samuel Van Eldik
- Posts: 16
- Joined: Fri Apr 01, 2011 11:55 am
- Location: Exmouth
- Contact:
Re: APPLY MTF RECREATE
- Capture.PNG (43.79 KiB) Viewed 114 times
-
Lee Gregory
- 12d Support
- Posts: 1944
- Joined: Thu Sep 29, 2005 6:06 pm
Re: APPLY MTF RECREATE
Samuel,
Nothing can be checked without the data.
If you don't want to post it here, send it to support@12d.com with a message saying what the problem is.
Nothing can be checked without the data.
If you don't want to post it here, send it to support@12d.com with a message saying what the problem is.
-
Samuel Van Eldik
- Posts: 16
- Joined: Fri Apr 01, 2011 11:55 am
- Location: Exmouth
- Contact:
-
Graeme Winfield
- Posts: 1645
- Joined: Thu Nov 10, 2005 10:59 am
- Contact:
-
Richard Mitchell
- Posts: 193
- Joined: Tue Apr 22, 2014 11:52 am
- Location: Melbourne
Re: APPLY MTF RECREATE
Hey Sam.
Didn't we need xml data because it had unique naming from the client and the dwg version of the same data had mini loops in part? From memory the dwg version failed to make cross sections all the way out.
What is the originating design software used? Give us a call if you like.
Didn't we need xml data because it had unique naming from the client and the dwg version of the same data had mini loops in part? From memory the dwg version failed to make cross sections all the way out.
What is the originating design software used? Give us a call if you like.
RMitchell
Arup
Arup