Report 3d lengths

Any questions regarding the practice version are asked and answered here.
Post Reply
Cameron Voss
Posts: 3
Joined: Wed Sep 19, 2018 8:43 am

Report 3d lengths

Post by Cameron Voss » Wed Sep 19, 2018 8:55 am

I can see that "Length Area [Report]" gives 2d length and
"Get Length in 3d [Strings->User]"gives 3d length , but can I get a report of 3d lengths (instead of doing them individually)?

Sam Cech
Posts: 3376
Joined: Fri Oct 14, 2005 12:56 pm
Location: Silverdale, NZ
Contact:

Post by Sam Cech » Wed Sep 19, 2018 9:54 am

for on screen results you could use
User =>Miscellaneous =>R to Z=>Sum length of all strings

or a report with
Report =>Quantities
it has a tick box for 3d length
Key should be *
Cheers
Sam

Tatras Consulting Ltd

Bernard Daly
Posts: 1348
Joined: Wed Nov 02, 2005 8:38 am

Post by Bernard Daly » Wed Sep 19, 2018 9:55 am

Cameron,

Have a play with Report>Quantities, go to the Lengths tab and check Use 3d length?. You can use a wildcard or be very specific for the Key/Name and you will need to assign a cost before it will generate a result (I use 0 or 1 unless you have an actual cost). Report mode of Summary is handy or set the mode to Full if you want a breakdown by string.
Last edited by Bernard Daly on Wed Sep 19, 2018 9:59 am, edited 1 time in total.

Sam Cech
Posts: 3376
Joined: Fri Oct 14, 2005 12:56 pm
Location: Silverdale, NZ
Contact:

Post by Sam Cech » Wed Sep 19, 2018 9:56 am

you could also try this
viewtopic.php?t=4306

Cameron Voss
Posts: 3
Joined: Wed Sep 19, 2018 8:43 am

Post by Cameron Voss » Wed Sep 19, 2018 10:30 am

[quote="Sam Cech"]you could also try this
viewtopic.php?t=4306[/quote]

I could not get to this location?

Cameron Voss
Posts: 3
Joined: Wed Sep 19, 2018 8:43 am

Post by Cameron Voss » Wed Sep 19, 2018 10:30 am

[quote="Sam Cech"]you could also try this
viewtopic.php?t=4306[/quote]

I could not get to this location?

Sam Cech
Posts: 3376
Joined: Fri Oct 14, 2005 12:56 pm
Location: Silverdale, NZ
Contact:

Post by Sam Cech » Wed Sep 19, 2018 11:08 am

Hi Cameron

you might need to register and sign in to the forum to access that post

Cheers
Sam

Post Reply