changing the datum value when producing cross sections

Any questions regarding the practice version are asked and answered here.
Post Reply
Kostandina Pangidis
Posts: 2
Joined: Fri May 30, 2014 11:49 am

changing the datum value when producing cross sections

Post by Kostandina Pangidis »

Hi there,

Does anyone know how to change the datum value when producing cross sections?
Owen Thornton
Posts: 5607
Joined: Tue Oct 04, 2005 12:50 pm
Location: Brisbane
Contact:

Post by Owen Thornton »

The datum value is automatically calculated for you, based on the data being plotted, and a few parameters on the following branches of the PPF Editor:
Boxes/Centreline labels=>Common parameters
Boxes/Centreline labels=>Boxes=>Datum lines
Boxes/Centreline labels=>Centreline=>Datum lines


If you want to set a constant datum, that can be a bit tricky. See this other post for one possible idea:
http://forums.12dmodel.com/viewtopic.php?t=1060
Kostandina Pangidis
Posts: 2
Joined: Fri May 30, 2014 11:49 am

Post by Kostandina Pangidis »

Thank you for your reply.
Post Reply