Add points on a string/alignment

[jay singh]

Received strings from designer for earthworks set out. I could see vertices on the strings. Is there a quick way to add points on the vertices in a view/alignment/model on string rather than individually clicking and adding point on each vertex. Thanks

[Bernard Daly]

If you want points instead of a line you can use Strings>Strings edit>Change then use the New point-line box to change to points.

If you want points and the original line then you could use Strings>Strings edit>Duplicate and then Change from line to points.

If you have a lot of strings to do you can use Utilities>A-G>Change to change the point/line type and use the Target box to either copy or overwrite your original data.

[jay singh]

Much appreciated. Thanks

[Guest]

Add points on a string or alignment. This is little bit difficult but in the time when you come on this https://addictionresource.com/addiction-and-rehab-hotlines/ site then you know that how can you add points on a string. Here is some of the best things which were tell you about how can you make it good for you.

[Luis Larson Luis Larson]

Main things which just help you and tell you how to allign all the things on the page. I would like to tell you everthing about resume valley reviews which is here according to you helping and hope that is good ever for you to align material for your work.

[Daniel Howell]

Thanks for the input Bernard Daly. Great to have solid folks in here quick to respond and help!
Daniel | https://www.photoboothwinnipeg.com/