Im getting an error as shown in the attached image.
When I try and run the drainage dynamic culvert design panel.4do it says array out of bounds.
Any ideas?
Cheers,
Zack
Dynamic Culvert Design Error
-
Zack Sokol
- Posts: 2
- Joined: Tue Jun 30, 2020 3:55 pm
Dynamic Culvert Design Error
Hey team,
Im getting an error as shown in the attached image.
When I try and run the drainage dynamic culvert design panel.4do it says array out of bounds.
Any ideas?
Cheers,
Zack
Im getting an error as shown in the attached image.
When I try and run the drainage dynamic culvert design panel.4do it says array out of bounds.
Any ideas?
Cheers,
Zack
-
Craig Smerdon
- Posts: 3
- Joined: Thu Dec 23, 2010 6:38 pm
Re: Dynamic Culvert Design Error
G'Day Zack
Did you get a response to this? I've just got the same issue after saving a dynamic culvert design. Can't open Dynamic Culvert Design at all in this project now.
Did you get a response to this? I've just got the same issue after saving a dynamic culvert design. Can't open Dynamic Culvert Design at all in this project now.
- Annotation 2020-08-17 142030.png (17.1 KiB) Viewed 4102 times
-
Zack Sokol
- Posts: 2
- Joined: Tue Jun 30, 2020 3:55 pm
Re: Dynamic Culvert Design Error
Hey Craig,
It was a data error already inside the dynamic culvert software by a previous user.
I believe we opened it on another person's machine somehow and edited the data that was sending it wonky.
It was a data error already inside the dynamic culvert software by a previous user.
I believe we opened it on another person's machine somehow and edited the data that was sending it wonky.