Plotting Trimesh to model - V11

[Colin Benjamin]

Can someone please advise how to get Trimesh to plot from x-sect view to model.

Using PPF, models are selected in corridor, turned on in X-sect view, but not displaying in plot model view.

Is there additional PPF data or tick box that needs to be completed?

Thanks

[Graeme Winfield]

Hi Colin

Sorry for the late reply, I missed your post.

Using 11.0C1q I am able to plot to model the trimeshes from the section view (Xplot PPF).
You may need to include the view that you are plotting. First item on the main branch.

What version/build of 12d Model do you have?

[Colin Benjamin]

Thanks Graeme,

I'm using version 11.0c1e. Yes have chosen the correct view to plot from, not sure why the trimesh is not showing up in the model plot.
I will have to look around for some training documents or similar to assist me with Trimesh's, definitely a great way to capture volumes.

Cheers
Col

[Owen Thornton]

It was a while ago, but I think this was still an issue back in V11C1e. I would say the solution is to upgrade to V11C1q, or V12C1m.

[Colin Benjamin]

Thanks Owen, I did wonder if that was the case, I will upgrade to V12 once I finish my current project, I'm a little cautious about updating in the middle of a project!!

[Kevin Astwood]

Hi,

Did this issue with plotting the trimeshes in the x-sec PPF get resolved? I have the same problem with the trimesh not showing in my x-sec plots even though the model is active in the corridor. I'm using v14.0C2k.

Thanks

[Graeme Winfield]

Hi Kevin

I think this one is fixed in a yet to be released version.

Can you email me some sample data, your PPF and the output (PDF) you get?