Corner of Grading Batter conflict

[Janet Manzano]

I got a building pad a closed polyline, what I did, I convert it to super alignment, assign a constant elevation, then create a template of 2m offset all around and downgrade it to 3% before use a 1:5 drape to existing ground, the result is not good looking, the corners are just joined instead of actual curved shaped grading, any idea to resolved it?

[Lucien West]

Project->management->defaults set Corner angle to something other than 0°.

This will help on outside bends, inside bends you will need to stop and start your template to stop the overlaps. Use an apply many.

[Janet Manzano]

its still not working sorry

[Lucien West]

There was a bug with corner angles in one or two of the releases, i think it was version 8.0c1g or 8.0c1f.
If your running one of these update your install to the latest 8.0c1p.

[Janet Manzano]

hi, im using Version 7
how can i email u the screen shot of the dwg i got now so u can see exactly whats happening?

thanks,
Janet