Offsetting BIM Stormwater Service Chambers

[Lewis Hazelton]

I am wondering if there is a way to offset or create rectangular service chambers which align with the lip line set out point as shown in RMS Standard Drawings. I would like to use the RMS standard drawing setout point to indicate face of pit at kerb lip line rather than just centre of pit.
Cheers Lewis

[Owen Thornton]

Yes. Go back to the source water model and edit it with the WNE. Setup a road design file to link a setout and centre string to each kerb inlet pit. Then use Adjust Pit Locations panel to laterally adjust all the kerb inlet pits, relative to the setout string, in one fell swoop.

A demonstration of this is shown in episode 3 of the training series linked here:
viewtopic.php?f=14&t=13401

Side note: you need to register and log in to the forum to get full access.