I have a job with a large amount of prisms to monitor.
Each monitoring section will have its own 2 control points. One half of the prisms shot from one and the other half the other.
Can I do a Standard Setup (Station and Backsight) and then just load in a measure rounds file with the monitoring prisms pre selected without having to do an initial sight of each prism before it begins measuring?
If I have to do an initial sight everyday, I might as well just use Setout Point and turn on Auto Turn 3D.
Thanks.
Measure Rounds
-
- Posts: 1745
- Joined: Fri Oct 21, 2005 8:47 am
Re: Measure Rounds
Not at the moment as such.
Perfect scenario for a custom macro to be run after the setup is done to generate the background measurement rounds file by the sound of it.
Are the points to be monitored unique id's in a single model?
Perfect scenario for a custom macro to be run after the setup is done to generate the background measurement rounds file by the sound of it.
Are the points to be monitored unique id's in a single model?
-
- Posts: 2
- Joined: Wed Jul 17, 2024 9:48 am
Re: Measure Rounds
Ah Spewin!
Yes all points have a unique ID and are within the one model.
I guess for now I will just use point setout and toggle on auto turn 3d and then just press next point number.
Yes all points have a unique ID and are within the one model.
I guess for now I will just use point setout and toggle on auto turn 3d and then just press next point number.