When creating a batter off a platform the corners are triangulating back on themselves. could someone suggest a solution?
Thanks,
Lauren
Interface
-
Dylan Revell
- 12d Support
- Posts: 310
- Joined: Thu Apr 05, 2007 2:46 pm
HI Lauren,
Do you meant that the generated sections "cross over" one another?
If you are only getting two sections around a corner (perpendicular to the platform segments) you can tell 12d to create additional sections around sharp corners by stting the Corner Angle (eg 15 degrees) in Project>Management>Defaults
Dylan
Do you meant that the generated sections "cross over" one another?
If you are only getting two sections around a corner (perpendicular to the platform segments) you can tell 12d to create additional sections around sharp corners by stting the Corner Angle (eg 15 degrees) in Project>Management>Defaults
Dylan