Update network from drainage.4d

Susannah Boer · Post by **Susannah Boer** » Fri Feb 07, 2014 5:36 pm

I keep getting the following message when using the drainage network editor.
" xx mode is different than the drainage.4d values. What would you like to do?"

ption 1: Update from drainage.4d
ption 2: Keep stored data

What happens for each option? what should I select?

Owen Thornton · Post by **Owen Thornton** » Fri Feb 07, 2014 6:02 pm

Unless you have received this drainage model from someone else and did not also receive their drainage.4d file, you should always say "update from drainage.4d".

This prompt will be less recurrent in V11.

Kelvin Jenkins · Post by **Kelvin Jenkins** » Mon Mar 24, 2014 3:40 pm

[quote="Owen Thornton"]Unless you have received this drainage model from someone else and did not also receive their drainage.4d file, you should always say "update from drainage.4d".

This prompt will be less recurrent in V11.[/quote]

Is there a way to reduce the number prompts in version 10?
I feel like I click the update button 100x a day

Cheers

Owen Thornton · Post by **Owen Thornton** » Mon Mar 24, 2014 4:09 pm

If you leave the DNE panel up as much as possible (rather than closing it), it may help. This will minimise the number of DNE sessions. In V10 the prompt can only be dismissed for the duration of the DNE session.